THE SHORT ANSWER
A reverse osmosis system with a storage tank should stop making water, and stop sending water to the drain, once the tank is full. The part that does this is the automatic shutoff device. EPA says that if you notice water continually being discharged to the drain, the shutoff device may need to be replaced (EPA WaterSense, Treating Water With Less Waste). Before replacing parts, rule out a tank that never fills (closed valve, clogged filters, or someone drawing water), and check for leaks.
FAQ (quick)
- Is it normal for RO to run after I use water? Yes. A tank system keeps producing water until the tank fills, then the shutoff device closes.
- Why won't my RO shut off? The shutoff device may have failed, or the tank isn't filling: a closed tank valve, clogged prefilters or a spent membrane, or a leak downstream.
- How much water is it wasting? EPA says a typical point-of-use RO system sends 5 gallons or more to the drain for every gallon it makes. While it runs nonstop, that waste keeps going.
- Can I keep using it? If you see a leak, close the system's feed valve and follow the manual. Otherwise, arrange service soon to avoid wasting water.
- Do tankless systems have this problem? They work differently: they make water on demand, usually with a booster pump. Follow your model's manual.
How a tank RO system is supposed to shut off
EPA's WaterSense specification requires labeled RO systems to have an automatic shut-off device, defined as a device that prevents reject water from being discharged when the system isn't treating water (WaterSense RO specification). EPA explains how it works: as the storage tank fills, pressure in the tank rises toward the pressure of the incoming water ("back pressure"). The shutoff valve closes when the back pressure reaches a set portion of the incoming pressure. That stops treatment, keeps the tank from overflowing, and stops water flowing down the drain (WaterSense specification supporting statement).
So the system can keep running for two broad reasons:
- The tank never reaches the shutoff point (it isn't filling, or water is leaving it), or
- The tank is full but the shutoff device isn't closing.
Safe checks you can do (no tools)
- Listen and look at the drain line. If water runs to the drain hours after anyone last used the RO faucet, write down the time. A short video helps a technician. For normal processing sounds, see RO drain noise.
- Check for leaks. Look in the cabinet and around the RO faucet and air gap without moving any tubing. If you find a leak, close the feed valve as your manual describes. See RO air-gap faucet leaks.
- Confirm the tank valve is open. If it was closed after a filter change, the tank can't fill.
- Check whether anything else draws from the RO. A refrigerator or ice-maker line connected to the RO system keeps using treated water. See refrigerator filter vs. kitchen RO.
- Check filter dates. EPA says most RO systems need prefilter replacement about every six months and membrane replacement every one to five years, depending on water quality and use. Low production is one sign maintenance is due (EPA). A slow system takes longer to fill the tank. See RO faucet slow flow.
- Look for recent changes. A plumbing repair, a power outage, or a long stretch away from home can change how the system behaves. See RO system after a power outage.
What a technician should check
Ask for a diagnosis tied to your exact model and manual:
- The automatic shutoff device. EPA notes it can fail and may need periodic replacement (EPA).
- Feed and tank pressure against the manufacturer's specs. The shutoff responds to tank pressure relative to incoming pressure, so both matter. Don't adjust a pressurized tank yourself unless the manual says how.
- Filters and membrane condition, plus the dates of the last changes.
- Any add-on parts. A permeate pump, for example, reduces back pressure from the tank and changes how the system behaves (WaterSense supporting statement). Make sure the technician knows the configuration.
Ask for a written note of what was measured and which part was replaced, and keep it with your maintenance record. See verify water treatment after installation.
Why fix it quickly: wasted water
EPA says a typical point-of-use RO system sends five gallons or more of reject water down the drain for every gallon of treated water, and some inefficient units send up to 10 gallons. WaterSense-labeled systems must send 2.3 gallons or less per gallon treated (EPA WaterSense RO). A shutoff that never closes keeps that reject stream flowing even when nobody needs water. If you're replacing an old unit anyway, compare efficiency ratings: RO efficiency and waste water explained.
Prevent it from happening again
- Keep to the prefilter and membrane schedule in your manual. EPA's general guide is prefilters about every six months and the membrane every one to five years.
- Drain the storage tank periodically, about every two weeks. EPA says this keeps water in the tank fresh and helps the membrane keep the pressure it needs. Many manufacturers also recommend sanitizing the tank once a year (EPA).
- EPA says a well-maintained RO system can last 15 years.
- Want someone else to track the schedule? See filter replacement and maintenance.
FAQ
My RO runs all night. Is the membrane bad? Maybe not. A failed shutoff device, a tank that won't fill, or a downstream leak can all cause it. Have the system diagnosed before replacing the membrane.
Does a constantly running RO hurt water quality? EPA ties low production and unexpected taste or odor to maintenance needs. If the taste changes, mention it when you book service.
Should I switch to a tankless RO? Tankless systems make water on demand, often with a booster pump, and take up less space (EPA). Compare the options in tank vs. tankless RO.
Do you service RO systems in North Port? Yes. Call 941-294-5767. Installation details: RO system installation in North Port.
Next step
Schedule an in-home water check or call 941-294-5767. Related: under-sink reverse osmosis · clean drinking water in North Port
Sources
Drafted 2026-11-10 (America/New_York); sources fetched the same day. Last fact-checked: 2026-11-10 (America/New_York).
PLANNING A NORTH PORT INSTALLATION?
Turn your questions into a clear scope.
Review the home details, equipment questions and ongoing care to discuss before booking. Address coverage and scheduling are confirmed during your callback.
View the North Port installation guideA PRACTICAL NEXT STEP
Drinking water, explained.
Fresh-tasting water for every glass, pot of coffee, and family recipe.
Explore this solution